Category: Gravitational Engineering

Comment on Cat and Plasma Ball, Rotating Plasma Ball, Plasma Ball and Fluorscent tubes and bulbs, iPhone

Cat and Plasma Balls at https://www.youtube.com/watch?v=XkJYY4dDdr0 The cat investigated all parts of the globe, power (it can smell the hands of the person on the plug most likely), and behavior (optical, response to touch and nearness, acoustic because its ears and nose can pick up more than our fat fingers) methodically. Its nose is rather
Read More »

Contact Imaging Sensors, Linear CCD arrays for gravitational and magnetic imaging

Jean, I was trying at least two pathways: 1. Build circuits to read the analog signals from these linear sensors, and put the fastest and best ADCs to read and store the data. The focus on high precision measurement of the signals as a function of reference voltage. 2. Somehow learn to talk to these
Read More »

Comment on plasma cutting video by Jason Michael Saunders, referring to 3D printed rockets

Comment on YouTube Jason, I watched this Genius of 3D Printed Rockets video the other day. They are using plasma discharge heating, but it is not very well controlled at all. They say “it works really precisely”, but it throws off heat and light and bits of wire, and fluctuates a lot. It only needs
Read More »

Create arbitrary fields through simulation, measurement, and calibration.

A wave traveling between two parabolic antennas https://www.youtube.com/watch?v=v0cZjOIfwos You might try receiver-transmitter pairs, where each inverts the signal to build a standing wave. Use the final state inside the volume (arbitrary and time dependent if you want) as the constraint, then solve for the signal modifications needed at each site. I first saw this more
Read More »

Thermodynamic Clocks – Time reversible systems, quality, gravitational detectors, solar system coordination

Shawn, Thank you for thinking of me, and sharing. The gravitational energy density (and the usually much smaller magnetic, electric and thermodynamic energy densities) control the rate of chemical, atomic and nuclear events at any location.  The most often used phenomena are “gravitational time dilation”, “relativistic or general relativistic corrections (from velocity and gravity)”.  An
Read More »

Comment on The 49 dollar, 500 WattHour eBike Battery video

https://www.youtube.com/watch?v=0FwA_s9Ovxc You talk about motivations for watching and DIY at about minute 14. The reason I am watching is I have a lifetime of learning how things work, what they can do, and how to put them into different combinations. Often the off-the-shelf parts don’t fit, or are overkill or too expensive. Mostly they just
Read More »

Comment on Video about laser interferometer design and use – replace superconducting gravimeters

Counting Atoms with the Doppler Effect – Heterodyne Interferometer by Sam Zeloof at http://sam.zeloof.xyz https://www.youtube.com/watch?v=vPu6lN9yJOY Sam, I sent you an email about using this to replace the network of superconducting gravimeters with something more people can afford. You have several orders of magnitude available to you by very small adjustments. SGs cost several hundred thousand and
Read More »

Plans for measuring the speed of gravity again, using superconducting gravimeter and related sensor networks

One linear regression is all that is needed to useg JPL Ephemeris to separate the sun moon from earth-based signals I want to repeat the SG network speed of gravity measurement I did in 2003 using all the current stations. I will also use the best of the broadband seismometers from IRIS.edu. Any absolute measurements,
Read More »

Post on the Facebook “Allsky Camera” group about satellite transits of star and other things

https://www.facebook.com/groups/172438633343696 Dear Allsky, I went through over a thousand live webcams on the Internet to see what people are sharing live now. My estimate is somewhere around 10,000 overall. Many of them have half sky (show half the image with sky) and in those they will capture comets, meteors, satellites, stars, planets, planes and many
Read More »

Some Notes on applications for MEMS gravimeters and their global calibration

Marley, For the last 20 years or so, I have been tracking gravimeter developments, hoping one day they could be developed enough to use in low cost gravitational imaging arrays. I don’t have my notes on what I wrote to you.  My memory is that I saw you were at “earth tide” sensitivity. That is
Read More »